CVE-2025-68331 | usb: uas: fix urb unmapping issue when the uas device is remove during ongoing data transfer

In the Linux kernel, the following vulnerability has been resolved: usb: uas: fix urb unmapping issue when the uas device is remove during ongoing data transfer When a UAS device is unplugged during data transfer, there is a probability of a system panic occurring. The root cause is an access to an invalid memory address during URB callback handling. Specifically, this happens when the dma_direct_unmap_sg() function is called within the usb_hcd_unmap_urb_for_dma() interface, but the sg->dma_address field is 0 and the sg data structure has already been freed. The SCSI driver sends transfer commands by invoking uas_queuecommand_lck() in uas.c, using the uas_submit_urbs() function to submit requests to USB. Within the uas_submit_urbs() implementation, three URBs (sense_urb, data_urb, and cmd_urb) are sequentially submitted. Device removal may occur at any point during uas_submit_urbs execution, which may result in URB submission failure. However, some URBs might have been successfully submitted before the failure, and uas_submit_urbs will return the -ENODEV error code in this case. The current error handling directly calls scsi_done(). In the SCSI driver, this eventually triggers scsi_complete() to invoke scsi_end_request() for releasing the sgtable. The successfully submitted URBs, when being unlinked to giveback, call usb_hcd_unmap_urb_for_dma() in hcd.c, leading to exceptions during sg unmapping operations since the sg data structure has already been freed. This patch modifies the error condition check in the uas_submit_urbs() function. When a UAS device is removed but one or more URBs have already been successfully submitted to USB, it avoids immediately invoking scsi_done() and save the cmnd to devinfo->cmnd array. If the successfully submitted URBs is completed before devinfo->resetting being set, then the scsi_done() function will be called within uas_try_complete() after all pending URB operations are finalized. Otherwise, the scsi_done() function will be called within uas_zap_pending(), which is executed after usb_kill_anchored_urbs(). The error handling only takes effect when uas_queuecommand_lck() calls uas_submit_urbs() and returns the error value -ENODEV . In this case, the device is disconnected, and the flow proceeds to uas_disconnect(), where uas_zap_pending() is invoked to call uas_try_complete().